Introduction: This article is focused on multi-homed EVPN setup that I have prepared in below network topology. One of the biggest advantage with EVPN that we get is multi-homing with it. Earlier with VPLS we did not have multi-homing integrated with the protocol. With multi-homing we can have one CE connected to two PE router… Read More GNS3 Lab Cisco : EVPN Multihome Concept and Configurations
Please Subscribe to my YouTube channel for regular updates. Hi Friends, After putting alot of efforts and trying different devices I was finally able to configure EVPN on GNS3 and so far it is working like a CHARM!! Follow the blog for complete story. EVPN is a service which provides control plane for the protocols… Read More GNS3 LAB Cisco : BGP-EVPN Single Home Configuration
This is a quick nugget kind of blog where we will see the configuration and working of the SRTE WECMP on IOS-XR device. We know how ECMP works basically if we have multiple paths available then we will use those paths to load balance the traffic and this is done in SRTE by default. With… Read More GNS3 Cisco Lab : SRTE(Segment Routing Traffic Engineering) WECMP(weighted ECMP) configuration on Cisco IOS-XR and IOS-XE routers.
Hi Friends, This is going to be a short and crisp article on MVPN Profile 0. I had some posts about L2VPN and L3VPN. In those posts I have discussed about unicast between the sites over MPLS ISP backbone. You can check my L2VPN and L3VPN posts here. L2VPN L3VPN In this post I am… Read More MVPN Profile-0 (Draft Rosen) Config on GNS3