I wrote few blogs on BGP EVPN and also on VxLAN earlier. My previous blogs were focused on IOS-XE and IOS-XR devices, recently I have started my Data Center journey and hence I wanted to do some labs on Nexus devices as well and what better place than GNS3 for this ? I got to… Read More GNS3 LAB Cisco : Nexus 9000v Control-plane based VxLAN BGP-EVPN Bridging Config and Verification.
I have written a few blogs earlier on VxLAN. You can check them in the below links. ASR1000 : VxLAN Unicast mode Configuration and Verification ASR1000: Cisco Vxlan Multicast Mode Configuration and Verification Since then VxLAN has changed a lot and I am planning to write a series of articles on VxLAN and EVPN on… Read More GNS3 Cisco LAB : Nexus 9000v NxOS VxLAN Lab and concept.
So far we have seen EVPN single home and EVPN multihome setup and configuration with Cisco csr1000v router. You can find the links for those posts below. EVPN -Single home GNS3 LAB Cisco : BGP-EVPN Single Home Configuration EVPN -Multi homeGNS3 Lab Cisco : EVPN Multihome Concept and Configurations Note : As per Cisco docs… Read More GNS3 LAB Cisco : EVPN (BGP/MPLS) IRB (integrated routing and bridging) Configuration and Verification.
Introduction: This article is focused on multi-homed EVPN setup that I have prepared in below network topology. One of the biggest advantage with EVPN that we get is multi-homing with it. Earlier with VPLS we did not have multi-homing integrated with the protocol. With multi-homing we can have one CE connected to two PE router… Read More GNS3 Lab Cisco : EVPN Multihome Concept and Configurations
Please Subscribe to my YouTube channel for regular updates. Hi Friends, After putting alot of efforts and trying different devices I was finally able to configure EVPN on GNS3 and so far it is working like a CHARM!! Follow the blog for complete story. EVPN is a service which provides control plane for the protocols… Read More GNS3 LAB Cisco : BGP-EVPN Single Home Configuration